Built on trust, delivered with integrity.

6 Reliable Companies. 8 Strategic Facilities.

STS Metals — Industry Insights
ForgingNovember 11, 2026
A machined titanium fitting inside the four allowance layers of a near-net forged block: workholding, cleanup, alpha case, and tolerance

Custom Sizes. Greater Possibilities.

Every job starts with the same question: how much material does it actually need? Across Sierra Alloys, Sierra Sheet & Plate, and TSI Titanium, STS Metals helps customers start closer to the finished part.

Read More
CompanySeptember 30, 2026
Forged Products, an STS Metals Company, over a glowing forging under the 6,500-ton press

STS Metals Acquires Forged Products Assets and Retains Its Experienced Workforce

STS Metals is proud to welcome STS Forged Products to the STS Metals family, adding a 6,500-ton open-die forging press that significantly expands the scale and range of forging capabilities available to our customers.

Read More
MaterialsSeptember 30, 2026
A saw cutting round blanks out of a titanium plate

Getting the Starting Size Right

Buy twenty pounds, fly one. On aerospace structural work, the ratio of what gets bought to what ends up flying commonly runs near ten to one, and on complicated parts it reaches twenty to one.

Read More
MaterialsAugust 18, 2026
A red-hot coil of wire glowing in a quench bath during heat treating

Why the Wire Surface Matters

Have you ever counted how many companies touch a fastener before it exists? One continuous surface runs through all of it, and the coating on that surface decides more than a purchase order line suggests.

Read More
AerospaceJuly 22, 2026
Turbofan schematic showing the titanium fan and compressor section and the nickel superalloy hot section

What Engine Programs Are Waiting On

In aerospace and defense, the engine is usually the part everyone is waiting on. Here is what goes into it, and why the schedule is the hard part.

Read More
AerospaceJune 12, 2026
Forge press in operation at STS Metals

Large OEMs Extend Long-Term Agreements with Manufacturers

In September 2025, STS Metals and Boeing announced an extended long-term supply agreement covering titanium rod, bar, and plate. That kind of agreement doesn't happen by accident.

Read More

Join our newsletter to stay updated